skid mounted diesel multistage water pump

Pump information

Multistage pumps are designed to transfer clean liquids through several impellers that are built into a series, as opposed to one and are typically useful in installations where a high head is needed. High-pressure applications can be achieved by installing the impellers on the same shaft of the multistage pump or parallel to each other on opposing shafts for higher flow rates. They are primarily useful for energy saving and different ranges of flow/head circumstances.

Pump specification

Pump feature

For this series horizontal multi-stage centrifugal pump, both ends of it are supported, the casing portion is in a sectional form, it is connected to and actuated by a motor via a resilient clutch and the rotating direction of it, viewing from the actuating end, is clockwise.

1.Stator portion

Consists of suck-in section, middle-section, spitting section, guide vane, packing etc., which are linked together with a take-up bolt, with both suck-in and spitting mouths vertically upward.

2. Rotor portion

Consists of a shaft, impeller, balancing disk, muff etc. parts

3. Bearing portion

The whole rotor is supported by the roller bearings or sliding bearings on both ends of the shaft and the bearings are lubricated with grease or 20# engine oil.

Pump application

· Pressure Boosting

· High-Pressure Shower/Spray (Sprinklers or Fire Fighting)

· Heating/Cooling Conditioning

· Reverse Osmosis

· Mine Dewatering

· Snow Making

· Boiler Feed

· Desuper heater Feed