150mm oultlet diesel irrigation water pump

Pump information

This pump is suitable  for industrial and city water supply, water drainage, and widely used for agricultural irrigation, transportation pure water or other liquids which physical and chemical nature is similar to  pure water, and the temperature should not be higher than 80℃ .

Pump data sheet

Performance curve

Pump assembly

Before assembly, first check if there is any defect with  the parts affecting the assembly and clean them.

1. Screw in the connecting bolts, screw corks on the corresponding parts in advance. 

2. Place the O-seal rings, paper pads, felts etc. on the  corresponding parts in advance. 

3. Put the sealing, packing, packing ring, packing gland  etc. in turn into the pump cover. 

4. Mount the rolling bearing on the shaft, then mount it into the suspended stand, put on the gland to press the rolling  bearing tightly and put the connecting bolt on the shaft. 

5. Mount the muff on the shaft, then mount the pump  cover on the suspended stand, mount the impeller, thrus t cushion, impeller nut etc. on and tighten them

 6. Finally mount the  assembly into the pump casing and tighten the connecting bolts  on both pump casing and cover. During the above assembly process, special attention has  to be paid to some small parts, such as flat keys, oil baffle disks, the O-seal rings inside of the muff of water baffle, which are easily missed or mounted in a wrong order. Carry out the reversed order to disassemble the pump.